BMW forum. Diagnostics, coding, programming, repair BMW vehicles.

BMW forum. Diagnostics, coding, programming, repair BMW vehicles. (http://bmwcoders.com/forum/)
-   BMW coding and programming (http://bmwcoders.com/forum/bmw-coding-programming-29/)
-   -   E39 + NCS EXPERT, dimmed high beam as DRL (http://bmwcoders.com/forum/bmw-coding-programming-29/e39-ncs-expert-dimmed-high-beam-drl-8956/)

zeniitti 02-19-2015 07:56 AM

E39 + NCS EXPERT, dimmed high beam as DRL
 
Hello folks, sorry if this is wrong section...

I coded dimmed high beam as DRL to 2003 530dAT with NCSexpert. I changed these settigns:
GED_FL_ALS_DRL - dimmed high beam as DRL --> aktiv
FL_DIMMUNG_ALS_DRL - dimming level for high beam as daylight --> wert03

This is also
AL_ALS_DRL - low-beam as DRL is nicht_aktiv.

I have light sensor (ALS) so xenons go on if surrounding lights go low enough. Normally I keep ligth switch on AUTO-setting. On daylight, I have dimmed high beams on, xenon off, AE off. When I switch light switch to 0 I have only dimmed high beams on. When I put my to parking mode, I have AE on but now also high beams on. Before codings, I had only AE on, other off. When I switch it to low beams, I have AE on, xenon on and dimmed high beams off.

Is it possible to code dimmed high beams on on parking mode? Then I would only have AE on. And I really would like to have all lights of when light switch is on 0 mode.

Thanks in advance!

doktorabg 02-20-2015 08:07 AM

No, it is impossible.

zeniitti 02-20-2015 08:59 AM

So when "GED_FL_ALS_DRL - dimmed high beam as DRL --> aktiv" no way to use only angel eyes :shock:


All times are GMT. The time now is 05:51 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.1
BMW forum: diagnostics, coding, programming.