BMW ICOM NEXT | BMW NBT EVO FSC Codes | BMW NBT & CIC FSC Codes | BMW Rheingold , ISTA/P, KSD, ETK remote installation | BMW STANDARD TOOLS remote installation | BMW ESYS remote installation
Go Back   BMW forum. Diagnostics, coding, programming, repair BMW vehicles. > BMWelcome > BMW coding and programming

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 05-29-2019, 12:05 PM
Junior Member
 
Join Date: Mar 2014
Location: swiss
Car: e39 528i
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
Default E81 2007 DME down grade

Hello

I did the call back from BMW about the under pressure breake sensore retrofit. Now after 2 months i always getting sommetimes the annoying unknown error code: 14082 which brings up the red engine warning together with an exessive use of braking error message.

Since the BMW guys are not able to solve that shit i plan to downgrade the DME firmware to one before that sensor was considered.

My question now should i need to save any settings before i upload the older DME Software with winkfp ?

Thx guys


Reply With Quote
  #2  
Old 05-30-2019, 02:39 AM
Junior Member
 
Join Date: May 2016
Location: NC
Car: E46
Posts: 6
Thanks: 0
Thanked 0 Times in 0 Posts
Default E81 2007 DME down grade

Yes i would. I didnít realize you can downgrade code on the dme however if you have the VO then theoretically you should be able to start from initial coding / programming if needed.

Last edited by charter21p5; 05-30-2019 at 02:42 AM.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT. The time now is 10:08 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.1
BMW forum: diagnostics, coding, programming.