BMW forum. Diagnostics, coding, programming, repair BMW vehicles.

BMW forum. Diagnostics, coding, programming, repair BMW vehicles. (http://bmwcoders.com/forum/)
-   BMW Programmers (http://bmwcoders.com/forum/bmw-programmers-28/)
-   -   Please help with x5 e70 key programming, couldn't start up the car (http://bmwcoders.com/forum/bmw-programmers-28/please-help-x5-e70-key-programming-couldnt-start-up-car-8863/)

victor5809 01-08-2015 08:34 AM

Please help with x5 e70 key programming, couldn't start up the car
 
Dear community :

after failed pairing new key on a BMW X5 2010 35i with digital master 3, both master key and aftermarket key were unable to code with vehicle. master key got locked.

Now, have dismantled cas board and successfully write empty channel into a new key,after completion, remote is working,key was recognized by vehicle but all it does was cranking, does not start the engine at all? Any clue?

after so many try.....starter motor died...

smartshah 03-03-2015 01:16 PM

Hi there this sounds like you may need to do a handshake between the DDE and the EWS. You can do this on INPA, handshake between the DDE and EWS.

And then do a handshake with the DDE and the CAS, you can do this in DIS V57. Under Control Functions, or Function Selection, Select Service Functions and then Drive and then CAS.


All times are GMT. The time now is 01:33 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.1
BMW forum: diagnostics, coding, programming.