BMW ICOM NEXT | BMW NBT EVO FSC Codes | BMW NBT & CIC FSC Codes | BMW Rheingold , ISTA/P, KSD, ETK remote installation | BMW STANDARD TOOLS remote installation | BMW ESYS remote installation
Go Back   BMW forum. Diagnostics, coding, programming, repair BMW vehicles. > BMWelcome > DIY guides

LinkBack Thread Tools Display Modes
Old 04-04-2016, 08:05 AM
Vin Vin is offline
Junior Member
Join Date: Apr 2016
Location: SAN BRUNO,CA
Car: 2010 535IX & 2011 535I
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
Unhappy Need Help....

Hi to all Bimmer Buddies

Need help, don't know which direction to go. I have 2010 BMW 535 ix, the water pump went bad so I changed both the thermostat and the pump. Car was fine for a week then i started to have issues. Having a hard time starting, have fuel in line, there sparks, takes me 5-6 cranks til it kick in. Soon as it kicks in the idle not steady, idle fluctuates up and down. Have engine malfunction displayed on the I-drive. Plugged the code reader and have these errors:

1. 3100- Boost Pressure control,deactivation
2. 2DEB- Power Management,vehicle electrical system
3. 2AA0- Camshaft sensor,inlet signal
4. 2A9B- Crankshaft-exhaust camshaft synchronization, also inlet
5.2AA3- Camshaft sensor, exhaust gap loss
6.2A80- Intake Vanos activation & Exhaust vanos activation

Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

All times are GMT. The time now is 03:50 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.1
BMW forum: diagnostics, coding, programming.